|
Hudson Star Classic Cut
Manual Putting Green Mower
FAQs
(Frequently Asked Questions)
Q: How much does the unit weigh?
A: The Classic Cut weighs 82 lbs.
Q: What is the cutting height range?
A: The cutting range is 1/8" to 3/4". This allows for
not only close golf course quality cuts, but allows trimming of fringe
areas and tees as well.
Q: How hard is it to change cutting heights?
A: It is very easy. The full cutting height range is accessed by
simply turning a single hand knob. There are no bolts or nuts to loosen
or tighten. There is no adjustment from side to side.
Q: How many blades does the reel contain?
A: The reel 11 blade reel is
balanced and backlapped at the factory and gives approximately 4 cuts
per inch.
Q: How easy is the Classic Cut to push?
A: Properly maintained, the Classic Cut is easy to push and can be used
by small adults and even fairly young children. Conditions such as dull blades
or excessively wet or tall grass will increase the force necessary and
will effect the quality of cut.
Q: How often will sharpening be required?
A: Normally very infrequent. Conditions such as frequency of mowing
cycles, condition of top soil, and frequency of top dressing can affect
the condition of the blade. Both units (Classic Cut and Signature
Series greens mowers) come with a backlapping kit
allowing the user to sharpen the cutting blades easily.
Q: Will the mowers catch grass clippings?
A: Yes! Clippings are collected in our unique molded catch can. The
can "clips" on the front of the mower allowing quick and easy dumping
and reattachment.
Q: How can I transport my mower from my garage to the
green since I have to travel over concrete, asphalt, stones, rougher
terrain, etc.?
A: The Classic Cut is manufactured with a unique multi-position handle
assembly which allows the unit to be transformed into a transportation
mode. Not only does it protect the cutting area of the mower, but it
allows the unit to be used as a "smoothing" roller for the green.
Q: What about maintenance?
A: Under normal conditions little maintenance is required. All
materials are powder-coated or manufactured from corrosion-resistant
materials. All bearings are sealed and the drive-train is enclosed
requiring no lubrication.
Q: Can the unit be shipped UPS?
A: Yes!
Q: How much does shipping cost?
A: Shipping is prepaid to the 48 contiguous United States.
Q: How soon can a unit be shipped?
A: Normal shipping time is within 48 hours.
Please click here to
see how long your mower will be in transit via UPS.
Q: Does the factory stock replacement parts?
A: Yes.
Q: Does the Classic Cut come with a complete and detailed
owners manual including identification of all replacement parts?
A: Yes! Please click
here if you would
like to download a copy of the owners manual in .pdf format.
Q: Should the Classic Cut be cleaned after mowing?
A: Normally light spraying with a water hose and lightly coating with
something similar to WD-40 is sufficient. |
